Campbell TurfWeather, Инструкция по эксплуатации

Страница: 52 / 81

TurfWeather Weather Station
e. Locate the other end of the battery pack cable on the main electronics
board. It terminates in a white connector plugged into the main
electronics board marked “Battery”. The wires are restrained along
their length with either plastic cable ties, or with reusable cable
restraints. Determine which type your weather station has and then
release the wires by either cutting the cable ties with the small wire
cutter, or by releasing the cable restraints. NOTE: Do not cut the wires
to remove the battery pack.
f. Disconnect the white battery pack cable connector from the main
electronics board. NOTE: Maintain ESD isolation by not touching any
electronics boards or components on the boards inside the weather
station.
g. Use the Phillips screwdriver to remove the two screws holding the
battery pack bracket into the electronics section, and remove the
bracket.
h. Lift the battery pack from the weather station. NOTE: The weather
station uses a maintenance free lead-acid battery and must be properly
disposed of. Do not dispose of this battery pack in a municipal
landfill, or by burning it. If you do not know where to dispose of a
battery pack, then contact your local solid waste disposal site for
instructions.
3. Battery Pack Replacement:
a. Insert the new battery pack into the weather station where the
previous battery pack was located.
b. Replace the battery pack retainer and tighten the Phillips head screws
that hold it into the electronics section. Take care not to crimp the
cable from the battery pack under the battery pack, or the retainer.
45