Campbell TurfWeather, Инструкция по эксплуатации

Страница: 66 / 81

TurfWeather Weather Station
d. Bring the weather station to an enclosed location, preferably near the
Host computer, and place it on a flat stable surface with an area of at
least three times the size of the weather station base.
2. Memory Battery Removal:
a. Invert the weather station main body and rest it on a support that
eliminates any stress on the wind speed or wind direction sensors,
and/or the rain gauge. A rolled bath towel placed in the center of the
main body, next to the rain gauge will generally suit the purpose.
b. Remove the seven Phillips head screws on the base of the main body
that hold the base section to the electronics enclosure section. Do not
remove the Phillips head screws that connect the mast bracket to the
weather station base. Notice that the three screws along the end with
the wind sensors are shorter that the remaining four screws.
c. Gently separate the electronics enclosure and base sections of the
weather station main body, taking care not to place any stress on the
wires that connect the two sections.
d. Rest the base section next to the electronics section and locate the
main electronics board within the electronics section. It is the largest
green rectangular electronics board in the weather station electronics
section. Locate the screws at the corners of the main electronics board
and touch one of them with a finger to discharge any electrostatic
difference between you and the electronics. NOTE: Touching the
screw(s) will not shock you or create a spark.
e. Locate the small disc shaped memory battery in the center of the main
electronics board and, using a fingernail, gently lift the battery
retaining clip; then use your wooden toothpick or non-metallic
tweezers to extract the battery from the battery holder.
3. Memory Battery Replacement:
a. Determine which side of the new battery is the positive side. This will
have a “+” stamped into the surface. This is the side that must be up
(visible) when the battery is installed in the battery holder.
b. Lift the battery retaining clip slightly and slip the battery into the
battery holder insuring that it is correctly seated and tightly held in
place by the battery retaining clip.
c. Place the two sections of the weather station main body together,
making sure that none of the wiring bundles will be crushed by the
edges or by the seven housing screws when the two sections are
secured with screws.
d. Reinstall and tighten the seven screws that hold the weather station
main body sections together.
59