Campbell TurfWeather, Инструкция по эксплуатации

Страница: 51 / 81

TurfWeather Weather Station
c. Remove the weather station from its location by using the ½ inch
wrench to loosen the two U-bolt nuts securing the weather station to
its mast. Make note of the orientation of weather station. NOTE: Do
not remove the mast bracket from the weather station.
d. Bring the weather station to an enclosed location, preferably near the
Host computer, and place it on a flat stable surface with an area of at
least three times the size of the weather station base.
2. Battery Pack Removal:
a. Invert the weather station main body and rest it on a support that
eliminates any stress on the wind speed or wind direction sensors,
and/or the rain gauge. A rolled bath towel placed in the center of the
main body, next to the rain gauge will generally suit the purpose.
b. Remove the seven Phillips head screws on the base of the main body
that hold the base section to the electronics enclosure section. Do not
remove the Phillips head screws that connect the mast bracket to the
weather station base. Notice that the three screws along the end with
the wind sensors are shorter than the remaining four screws.
c. Gently separate the electronics enclosure and base sections of the
weather station main body, taking care not to place any stress on the
wires that connect the two sections.
d. Rest the base section next to the electronics section and locate the
battery pack within the electronics section. It is a gray and black
rectangular component at the front of the electronics section. It is
retained by a white metal bracket that is held in place with two
Phillips head screws. There is a cable, consisting of a red and a black
wire, or a white and black wire that connects the battery pack to the
main electronics board.
44