Campbell TurfWeather, Инструкция по эксплуатации

Страница: 22 / 81

TurfWeather Weather Station
2. Connect the serial cable male connector to the radio connector marked
RS232 and the female connector to a computer serial port (Figure 1-6).
FIGURE 1-6. Radio connections. The serial cable (left) connects to the
port marked RS232 and the AC adapter connects to the port marked
DC Pwr input.
3. Plug the RF401 AC Adapter into a grounded AC wall outlet.
4. Connect the other end of the AC adapter to the RF401 connector marked
DC Pwr input (Figure 1-6). The red Pwr/Tx status light should illuminate.
5. Start the Campbell Scientific PC200W software. Click on Connect. Click
on the Monitor Data tab to confirm communication.
6. Monitor the sensor displays. After a few minutes, numeric values should
appear if the weather station and radio are communicating. Also indicator
lights on the RF401-series radio will blink.
If the radio is not communicating properly, you may be
experiencing interference from nearby equipment such as
wireless phones, other spread spectrum radios, or another
TurfWeather weather station. Changing some settings on your
radio and weather station should rectify this situation. Contact
your local distributor for assistance. NOTE
7. If your radio is working properly, close the Campbell Scientific PC200W
software and turn the key to the off position. You are now ready to install
your weather station at the site. Turn off key switch on weather station
and Proceed to the TurfWeather Site Installation Guide.
15