Campbell TurfWeather, Инструкция по эксплуатации

Страница: 65 / 81

TurfWeather Weather Station
3.17 Memory Battery (P/N 15598) Removal and Replacement
Procedure
The removal and replacement of a TurfWeather weather station memory
battery does not require training, special tools, or test equipment. However, the
main body of the weather station does need to be opened, and the person
replacing this electronics board should observe basic electro-static discharge
(ESD) precautions (described below) to avoid damage to the weather station
electronics inside the main body of the weather station. There is no personal
electrical hazard involved, and this procedure can be accomplished by anyone
possessing basic mechanical skills. Please read this entire procedure before
beginning work.
Tools Required:
9
½ inch wrench
9
5/16 inch wrench
9
#2 Phillips screwdriver
9
Wooden toothpick or non-metallic tweezers
1. Preparation:
a. Turn the power switch on the weather station to the “OFF” position.
b. Disconnect the power input cable and ground wire connections from
the weather station, using the 5/16 inch wrench for the ground wire
connection.
c. Remove the weather station from its location by using the ½ inch
wrench to loosen the two U-bolt nuts that secure the weather station to
its mast. NOTE: Do not remove the mast bracket from the weather
station.
58