Campbell TurfWeather, Инструкция по эксплуатации

Страница: 70 / 81

TurfWeather Weather Station
3.19 Spread Spectrum Radio (all frequencies) Removal and
Replacement Procedure
The removal and replacement of a TurfWeather weather station spread
spectrum radio does not require training, special tools, or test equipment.
However, the main body of the weather station does need to be opened, and the
person replacing this radio module should observe basic electro-static
discharge (ESD) precautions (described below) to avoid damage to the radio
module and/or the weather station electronics inside the main body of the
weather station. There is no personal electrical hazard involved, and this
procedure can be accomplished by anyone possessing basic mechanical skills.
Please read this entire procedure before beginning work.
Tools Required:
9
½ inch wrench
9
5/16 inch wrench
9
#2 Phillips screwdriver
1. Preparation:
a. Turn the power switch on the weather station to the “OFF” position.
b. Disconnect the power input cable and ground wire connections from
the weather station, using the 5/16 inch wrench for the ground wire
connection.
c. Remove the weather station from its location by using the ½ inch
wrench to loosen the two U-bolt nuts that secure the weather station to
its mast. NOTE: Do not remove the mast bracket from the weather
station.
d. Bring the weather station to an enclosed location, preferably near the
Host computer, and place it on a flat stable surface with an area of at
least three times the size of the weather station base.
63