CADDX RANGER 7600, Руководство по установке

Страница: 8 / 38

8
PROGRAMMING THE COMMUNICATOR
PAGES 8 & 9 DESCRIBE ALL THE LOCATIONS WHICH MUST BE PROGRAMMED IN ORDER FOR
THE RANGER 7600 TO FUNCTION AND REPORT TO A CENTRAL STATION. OTHER OPTIONS
MAY BE SELECTED BY FOLLOWING THE ADDITIONAL PROGRAMMING INSTRUCTIONS.
LOCATIONS 032-047: PROGRAMMING THE PRIMARY TELEPHONE NUMBER
The primary telephone number is programmed in successive locations beginning with location 032. Any zero (0)
within the telephone number, must be programmed as a "10".Programming a "0" will indicate the end of the phone
number. Four second delays can be programmed at any point in the phone number by programming a "13" in the
location where a delay is desired. If a "
r
" or "#" are required in the phone number, an "11" = "
r
" and "12" = "#". If
tone dialing is desired, program a "15" in the location where tone dialing should begin. If the entire number should
be tone dialing, program a "15" in location 032.
LOCATIONS 048-051: PROGRAMMING THE ACCOUNT CODE FOR THE PRIMARY PHONE NUMBER
The account code sent when the PRIMARY phone number is dialed is programmed in locations 048-051. Any zero
(0) within the account code must be programmed as a "10", and the communicator will report a zero (0). If the
account code is three digits long, use locations 048, 049, and 050. Program a "0" to indicate the end of the account
code.
LOCATION 052: PROGRAMMING COMMUNICATOR FORMAT FOR THE PRIMARY PHONE NUMBER
Location 052 contains the communicator format used to transmit to the receiver connected to the primary phone
number. Consult the instructions for your central station receiver to determine which format is compatible. To
select Universal 4 + 2, program a "1" in location 052. Contact ID requires a "13" in this location. If you need
another format, choose from those listed in the format table located on the following page, and program the data
in location 052. If this location contains a "0", the built-in communicator will be disabled, and the Ranger 7600 will
function as a local only control.
LOCATION 053: SECONDARY TELEPHONE NUMBER SEQUENCE CONTROL
Location 53 is used to control the secondary telephone number. If location 53 contains a" "0 the secondary phone
number is used as a backup to the primary number. Programming a "1" in location 53 will cause the secondary
number to be used only with dual and split reporting (no backup reporting enabled). Programming a "3" in location
53 will cause the control to alternate between the primary and secondary number (2 calls each) for the number of
attempts programmed in location 134.
LOCATIONS 054-069: PROGRAMMING THE SECONDARY TELEPHONE NUMBER
Locations 054-069 contain the secondary telephone number. This number allows certain communicator reports to
go to another number, or to cause the communicator to dial a second number if the primary number does not
respond after the number of attempts programmed into location 134 have been tried unsuccessfully. The same
number of attempts are made with the back-up number. Tone dialing and delay instructions are the same as for the
primary number.
LOCATIONS 070-073: PROGRAMMING THE ACCOUNT CODE FOR THE SECONDARY PHONE NUMBER
The account code sent when the Secondary phone number is dialed is programmed in locations 070-073. Any
zero (0) within the account code must be programmed as a "10", and the communicator will report a zero (0). If
the account code is three digits long, use locations 070, 071, and 072. Program a "0" to indicate the end of the
account code.