CADDX RANGER 7600, Руководство по установке

Страница: 18 / 38

18
LOCATION 145-148: PROGRAMMING THE AUXILIARY OUTPUT
The 7600 has one auxiliary output located on terminal 11 on the control PC board. This output can be activated by
four different conditions selected from the 16 options in the following table. To utilize this output, program locations
145-148 with a number from "0" to "15" in accordance with the desired characteristics listed below. The output will
trigger for any of the activations programmed in any of these locations.
AUXILIARY OUTPUT TABLE
PROGRAM DIGIT ACTIVATION ON NOTES
“0" DISABLED DISABLED
“1" BURGLAR ALARM MOMENTARY OUTPUT
"2" FIRE ALARM MOMENTARY OUTPUT
"3" PANIC ALARM/DURESS MOMENTARY OUTPUT
"4" ARMED STATE LATCHED OUTPUT
"5" AC POWER LATCHED OUTPUT
"6" LOW BATTERY LATCHED OUTPUT
"7" LINE SEIZURE MOMENTARY OUTPUT
"8" TAMPER ALARM LATCHED OUTPUT
"9" AUTOTEST MOMENTARY OUTPUT
"10" RESERVED NOT USED
"11" ALARM MEMORY LATCHED OUTPUT
"12" ENTRY LATCHED OUTPUT
"13" EXIT LATCHED OUTPUT
"14" SMOKE DETECTOR POWER LATCHED OUTPUT
"15" GROUND START MOMENTARY OUTPUT
LOCATIONS 149: INVERTING THE AUXILIARY OUTPUT
The auxiliary output of the 7600 is normally POSITIVE (+) going NEGATIVE (-). It can be changed to a normally
NEGATIVE (-) going POSITIVE (+) by programming a 1 in location 149. {NOTE: CURRENT LIMITED TO 250
MICRO AMPS POSITIVE AND 20 mA NEGATIVE).
LOCATION 150: AC POWER LOSS DELAY FEATURE
Location 150 contains the number of 2 minute delays (2 to 30 minutes) the communicator will wait before reporting
an AC power failure. A "1" programmed in this location will create a two minute delay, and a "15" will create a 30
minute delay. If a "0" is programmed in this location, AC power failures will be reported WITHIN 30 SECONDS if AC
power loss reporting is enabled in locations 120-121.