CADDX RANGER 7600, Руководство по установке

Страница: 26 / 38

26
LOCATIONS 212-239: PROGRAMMING THE ARM/DISARM CODES FOR USERS 8-14
Locations 212-239 contain the arm/disarm codes for user numbers 8-14. These codes can be accessed only in the
program mode, or through downloading.
LOCATION 240: ENTERING THE NUMBER OF DIAL ATTEMPTS TO SECONDARY PHONE NUMBER
Location 240 is used to enter the number of dial attempts (1 to 15 attempts) the communicator will try to the second
phone number before ending the notification process. If this location contains an "8", the communicator will make
8 attempts to the second number, if a second number is programmed. If this location contains a "0", the number
programmed in location 134 will be used.
LOCATION 241-243: RESERVED
LOCATIONS 244-249: ASSIGNING SPECIAL CHARACTERISTICS FOR ZONES 1-6
Locations 244-249 are used to assign individual characteristics for each of zones 1-6. These locations can be used
to enable or disable the Trouble Reporting, Group Bypass, Entry-Guard, and Cross Zone feature for each of the
individual zones 1-6. To enable these features, enter a binary number according to the following chart:
VALUE DESCRIPTION
1 Cross Zone
2 Entry Guard Zone
4 Group Bypass Zone
8 Trouble Reporting
CROSS ZONING - This feature requires a trip on 2 or more zones programmed as Cross Zones within the time
frame programmed in Location 255 (1-15 minutes). It is important that at least 2 zones be programmed for cross
zoning if this feature is to be used. First zone trip will initiate the keypad sounder, second zone trip creates an alarm.
Either can be silenced by entering a valid code.
ENTRY GUARD - Enable this feature by adding a "4" to the number programmed in location 131. Program the
zone(s) that you wish to be monitored (armed) with a “2". When enabled, all non Entry-Guard zones will be bypassed
and all other zones will be delayed when the "Instant" LED is illuminated. When the "Instant" LED is off, all non
bypassed zones will resume their normal characteristics. To arm the 7600 in “Entry Guard” mode, press [2]. To
disarm, press [2] or your user code. If you wish to suppress the use of the [2] as a disarming key, add an “8" to the
number programmed in location 131.
NOTE : The Entry Guard entry timing will follow the Primary entry time.
GROUP BYPASSING - This feature will allow all zones programmed as group bypass zones to be bypassed by
entering [
r
] [9] [
r
] when the control is disarmed.
LOCATION 250-251: RESERVED