CADDX RANGER 7600, Руководство по установке

Страница: 22 / 38

22
LOCATION 180: PROGRAMMING THE LOOP RESPONSE TIME
Location 180 is used to program the loop response time for all zones programmed as fast loop response in locations
186-193. The response time is equal to 20 milliseconds times the number programmed in this location ("1" = 20
milliseconds and "5" = 100 milliseconds). If this location contains a "0", the loop response time will be 500
milliseconds.
LOCATION 181: AUTOTEST SUPPRESSION
Programming a "1" in location 181 will cause the 7600 to suppress an autotest report if the communicator has sent
any report since the last autotest. Programming a "0" in location 181 will cause all autotest reports to be sent. Factory
default is a "0".
LOCATION 182: FORMAT OVER-RIDE LOCATION
The number selected in this location will select the format options as follows:
VALUE DESCRIPTION
1 Add for extended reporting
2 Add for hex digits allowed
4 Add for 20PPS
8 Add for 10PPS
LOCATION 183: FORMAT OVER-RIDE LOCATION
The number selected in this location will select the format options as follows:
VALUE DESCRIPTION
1 Add for 1800hz transmit
2 Add for 2300hz handshake
4 Add for single round parity
8 Add for 2 digit event code
LOCATIONS 184-185: RESERVED
LOCATIONS 186-191: ASSIGNING SPECIAL CHARACTERISTICS FOR ZONES 1-6
Locations 186-191 are used to assign individual characteristics for each of zones 1-6. These locations can be used
to enable or disable the chime feature, restore reporting, bypass feature, and fast loop response for each of the
individual zones 1-6. Add the sum of the features you desire and program that number in Locations 186-191.
Factory default is “6".
VALUE SPECIAL CHARACTERISTICS
1 Fast loop response time (see location
180)
2 Bypass Capability
4 Zone Restoral Reporting
8 Chime enable