CADDX RANGER 7600, Руководство по установке

Страница: 15 / 38

15
LOCATION 124: PROGRAMMING FOR PRIORITY ZONE TROUBLE REPORTING
The Ranger 7600 has the ability to report a trouble code each time a Priority zone opens. The desired trouble code
is programmed in location 124. If this location contains a "0", the Priority Trouble will not be reported. When Contact
ID is selected, program the location with any number to activate this report.
LOCATION 125: PROGRAMMING FOR ZONE BYPASS REPORTING
The Ranger 7600 has the ability to report a bypass on zones 1-6. The desired bypass code is programmed in
location 125. If this location contains a "0", zone bypass will not be reported. The bypass will be reported at the end
of the exit delay for non-24 hour zones. 24 hour zones will report a bypass immediately. When a bypass is removed,
a restore will be reported if "Restore" is enabled in location 126. When Contact ID is selected, program with any
number to activate this report.
LOCATION 126: PROGRAMMING THE COMMUNICATOR CODE FOR RESTORAL
Location 126 contains the communicator code that will be sent for restoral of a zone. If this location contains a "0",
no restorals will be reported. If a restoral code is programmed and an extended format is selected, the restorals will
be reported by zone. If a restoral code is programmed and an extended format is not selected, a restoral code will
be sent when all of the previously reported conditions have restored. When Contact ID is selected, program with
any number to activate this report.
LOCATION 127: PROGRAMMING THE COMMUNICATOR CODE FOR CANCEL (EXCEPTION OPENING)
Location 127 contains the communicator code that will be sent for cancel. The cancel code programmed in this
location will be sent if an arm/disarm code is entered after a trip on zones 1 through 6 has been reported (excluding
24 hour zones). After a cancel has been reported, no loop restorals will be transmitted on non-24 Hour zones. If this
location contains a "0", cancel is disabled. When Contact ID is selected, program with any number to activate this
report.
LOCATION 128: PROGRAMMING ABORT DELAY BEFORE DIAL TIME
Location 128 is used to enable the communicator abort. The number programmed in location 128 is the number of
2 second increments the communicator will delay before dial of a burglary alarm. If an arm/disarm code is entered
during this delay the 7600 will abort the transmission. If this location contains a "0", the Ranger 7600 will not abort
any reports.
(24 hour Zone will not abort)
LOCATION 129: PROGRAMMING FOR SILENT PANIC/HOLD-UP
Location 129 is used to silence the audible output for a panic/hold-up alarm. Programming a "1" in this location will
silence the audible output during a panic/hold-up alarm. If this location contains a "0", the Ranger 7600 will have an
audible panic/hold-up output.
LOCATION 130: LIMITED SIREN AND/OR COMMUNICATOR OUTPUTS
Location 130 is used to limit the sirens or the communicator, or both, to one output per zone during a single arming
cycle. The following table will indicate the value to be programmed in location 130 to give the 7600 the desired
characteristics. Factory default is "0", unlimited siren, and unlimited reports for the communicator.
VALUE DESCRIPTION
0 SIRENS AND COMMUNICATOR NOT LIMITED
1 SIREN ONCE PER ZONE, COMMUNICATOR NOT LIMITED
2 COMMUNICATOR ONE REPORT PER ZONE, SIREN NOT LIMITED
3 SIREN AND COMMUNICATOR LIMITED TO ONCE PER ZONE