Burk GSC3000, Руководство по установке и эксплуатации

Страница: 50 / 149

Abandoning Changes / Restoring Default Settings
There are two ways to abandon configuration changes:
T To o a ab ba an nd do on n cch ha an ng ge ess a an nd d sstto op p e ed diittiin ng g, simply close the Configuration window and choose No when asked if you
would like to save your changes. No changes will be made to the unit configuration.
T To o a ab ba an nd do on n cch ha an ng ge ess a an nd d rre esstta arrtt e ed diittiin ng g w wiitth h tth he e lla asstt--ssa avve ed d sse ettttiin ng gss, select Revert from the Configuration
window toolbar. This will restore the settings last saved to the I/O unit.
Note: If you are working from an archived .set file and wish to discard changes, re-open the archive file or close the
Configuration window.
To restore the factory-default settings to your I/O unit, select Set to Default Values from the Configuration
window’s File menu.
Note: To restore previously saved data for the current menu tab only, select Re-Download Selected Data from the
File Menu in the Unit Configuration window.
Printing the Unit Configuration
So that operators may easily reference channel assignments and other configuration settings, it may be useful to
print your unit configuration. To do so, click the Print icon in the Configuration window toolbar. You may also
preview the printout by choosing Print Preview from the File menu.
Note: The File menu in the Configuration Window also provides access to the Macro Editor. See chapter 10).
CALIBRATION
The Calibration window is where you calibrate the I/O
unit’s meter readings so that the values reported by
the unit match those of the monitored equipment. If
you are setting up a new site, you need to finish
configuring all the units at your site and go on to set
up modems and connect your site equipment before
calibrating your I/O unit (see Chapter 6). Once this is
done, you are ready to calibrate.
In order to correctly calibrate the metering channels,
you must be direct-connected at the transmitter site or
remotely connected and in communication with
someone in the field who can report actual equipment
values.
To calibrate an I/O unit’s metering channels:
1. Select the desired unit in the Site List.
2. Open the calibration window by expanding S Se elle ecctte ed d U Un niitt from the S Siitte e menu and choosing C Ca alliib brra attiio on n.
3. Click on the metering channel you would like to calibrate, enter the correct metering value at the bottom
of the dialog box, and click C
Ca alliib brra atte e.
GSC3000 & VRC2500 INSTALLATION & OPERATION MANUAL
CHAPTER 4: I/O UNIT CONFIGURATION
42