Brusa EVB1-350-40-HP, Технические данные и запуск

Страница: 46 / 98

Technical data
and start-up
EVB1-350/400-40-HP
46
7.3.1 Pin 1 GND
INFORMATION
If the battery control signals are connected with other vehicle components, then the connection to the
vehicle's ground must take place at this pin.
Internal wiring
1
M
Ω
2
3
,5
μF
Pin 1 GND
housing

Direct ground connection of the battery's control electronics.

The signal ground is connected with the battery housing through a few components. These components serve
for self protection and constitute a defined connection.
7.3.2 Pin 2 AUX
INFORMATION
We recommend using a 15 A fuse for this pin on the 12 V battery (LV supply).
The voltage range for pin 2
AUX = high is between 9
– 15 V.
The battery is generally ready for operation when the following requirements are met:

Voltage is applied at pin 2 AUX (terminal 30)

Pin 3 EN is high

Pin 1 GND (terminal 31) is connected

No error messages present
Internal wiring
7,5
μH
1
,7
6
μ
F
Pin 2
AUX
Internal
Supply
PTC
9A
33V
The internal 5 V supply is generated with this pin and offers the following possibilities:

CAN communication

Microprocessor Programming (Firmware)