background image

 

 

Wireless Doorbell with Standard or Illuminated Chime 

Models Covered: 250-016 & 250-033 

· 

Blue Doorbell unit with 1 x TX15 Allen Key & 2 x Anti-tamper Screws 

· 

Transmitter unit (with double sided sticky pad) 

· 

Illuminating Door Chime Unit (complete with wall fixings) 

· 

2 x C Battery 

Pack Contents 

· 

Blue Doorbell unit with 1 x TX15 Allen Key & 2 x Anti-tamper Screws 

· 

Transmitter unit (with double sided sticky pad) 

· 

Standard Door Chime Unit (complete with wall fixings) 

· 

2 x AA Battery 

OR 

Product Overview 

The wireless Doorbell uses radio frequency (RF) technology to activate a separate door chime unit, with the 
Doorbell acting as the transmitter (once fitted) and the door chime unit as the receiver. There are over 250 RF 
channels that the Doorbell and door chime unit can operate on and the units come supplied with a standard 
factory default channel setting. Channel settings can easily be changed and further details on this can be 
found in the 

Channel Set up

 section. 

 
The Doorbell has been designed to be attached to the outside of the designated entrance with the supplied 
transmitter wired into it from the inside. By pressing the button on the outside Doorbell, the Doorbell transmits 
the signal to the door chime receiver and the chime will activate.    
 

Please read and follow the instructions below before attempting to activate or install your Doorbell and door 
chime. It is recommended that you retain a copy of these instructions for future use.   

   

Initial Set up Instructions 

 

1. 

Check contents of pack and ensure all components listed are present. Contact your suppliers if anything    

 

is missing. 

 
2. 

Before permanently fitting the Doorbell and door chime unit into place, first test the system. Wire the 

 

transmitter into the back of the Doorbell by attaching the positive white wire to terminal A and the grey   

 

wire to terminal C (ensuring the correct polarity). Then activate the battery in the transmitter by removing 

 

the battery pull out tag located on the side of the unit and then insert the supplied batteries into the door 

 

chime (please see 

To fit or replace batteries

 below).  

Please note the battery in the transmitter should 

 

be activated before inserting the batteries into the door chime. 

With the batteries activated, this enables 

 

the pairing of the system. A double beep will be heard to indicate a successful pairing. At this point press 

 

the button on the Doorbell within 30 seconds to confirm activation.

 

 

 

3. 

With a successful pairing of the two devices, you may proceed with the fitting of the Doorbell and door 

 

chime units as described (please see 

Doorbell & Transmitter Fitting Instructions

 below). Remember 

 

you will need to remove the wires from the Doorbell terminals A & C and reattach them to the Doorbell 

 

when permanently fitting the device into place.

 

 

4. 

Should the units not pair, please remove the batteries from the door chime for 30 seconds. Then           

 

re-insert the batteries at which point a double beep will be heard. This indicates that a successful pairing 

 

has been achieved and the Doorbell button should be pressed within 30 seconds to confirm the         

 

activation. If this process fails to pair the devices, please refer to the 

Trouble Shooting Guide and 

 

User Hints

 section.

 

 

Please note the Doorbell has a built in anti-annoyance feature that restricts the activation of the device, please 
read the 

Operation section 

for more details. 

Содержание 250-033







Отзывы: