install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
Broadcast Pix
V3.0
To assign a source to a Keyer:
1.
Press the desired Key Selection Button in the Destinations Row, either
[Key 1
Select]
,
[Key 2 Select],
[Key 3 Select], [Key 4 Select], [Key 5 Select]
or
[Key 6 Select]
.
The button pressed will illuminate orange (or red if the key is on Program), and
one button in the Sources Row will also illuminate. This lit button in the source
row will indicate which source is currently assigned to the selected key. For
example, in the illustration shown below, Input 1 is fed into Key 1.
(You can see the input number or device name of the source by looking on the
top of the PixButtons in the destination row).
The lit source button will illuminate red if this key is on program. This will warn
you that if you now change to a different source you will be impacting the on-air
content. The lit source button will illuminate orange if this key is not on air. If a
shifted source (17-32) is currently in the key, it will blink on the Control Panel,
and illuminate a small red light above the button on the SoftPanel.
4.4.2 Assigning a Source to Key 1-6
Each of the six keys may hold a variety of sources, including a cg, animation, still, a
DVE box (picture-in-picture) for a camera, etc. Each source is assigned to Key 1-6
by using the Key Selection buttons and Source Row buttons.
2.
Press the desired
[Source Row]
button, for the source you wish to feed into the
keyer. The button pressed will illuminate orange (or red if the key is on Program),
and the source row button that had been illuminated before will go out.
Only one button in the source row may be illuminated at a time. The new source,
and its current contents, will also appear in the appropriate [Direct Key] PixButton.
Key Select Buttons
in the Destinations Row
Sources Row
Display in Macro Row
4.4.2