Black Box ServLink ACR3500A, Руководство пользователя

Страница: 24 / 115

23
CHAPTER 3: Installation
3.1.7 A
TTACHING
P
OWER
M
ANAGEMENT
M
ODULES
(P
OWER AND
S
ERIAL
D
ATA
, O
PTIONAL
)
How you attach a ServLINK Power Management Module (our product code ACRPWR)
to a main ServLINK unit depends on whether the Module will be controlling
power to the ServLINK itself (see
Section 3.1.7.A ) or to an attached computer,
router, etc. (see
Section 3.1.7.B
).
Important:
Any non-included power cords used
with the Management Modules must be rated for 15 amps minimum. For more
complete information about these Modules, consult their own manual.
3.1.7.A Installing the Module Controlling Power to the ServLINK
Take these steps to install any Module you’ll be using to control power to the
ServLINK itself:
1. If the ServLINK is powered, power it down.
2. Plug one of the RJ-45 cables included with the Management Module into the
“DATA IN” port on the Module, as shown in Figure 3-8.
Figure 3-8. Attaching an RJ-45 cable to the Power Management Module.
3. Plug the other end of this cable into the port marked “DATA” on your
ServLINK’s Access Card, as shown in Figure 3-9.
Figure 3-9. Attaching the same cable to the ServLINK.
RJ-45 control cable to
ServLINK
RJ-45 control cable from
Management Module