BERTHOLD TECHNOLOGIES NightOWL II LB 983, Руководство по эксплуатации

Страница: 131 / 136

LB 983 NightOWL II Operating Manual Appendix
127
10.4 NightOWL II Shipping instructions
The NightOWL II must be shipped with the camera removed and the foam piece laid on the bot-
tom plate fixed with the camera lift as shown below:
Proceed as follows:

Remove all filters from the filter wheel (empty wheel mounted) and other accessories from the instrument
and place the foam piece on the base plate as shown above.

Move the camera (z-axis) into the transport position (step 98000 see 6.10.5) using the service software or
indiGO.

The camera drive will block the foam piece and locks the base plate.

Switch off the NightOWL II and do not turn it on again since it will move back to the home position.

Remove the air adapters from the camera, open the 2 thumb screws left and right of the camera, unplug
the USB cable and Power supply and carefully take out the camera.

Fix the transport holder for the air adapters as shown on Fehler! Verweisquelle konnte nicht gefunden
werden. . Use the grey spacers to avoid touching the lens.

Clip the air adapters to the holder so that they are magnetically fixed.

Remove the power supply cable from the instrument and place it in the
camera box.

Unscrew the noise killer at the top rear side of the NightOWL and place
it in the camera box.

Close the front door and put the NightOWL in the flight case. Close all
Butterfly locks

Make sure that the blank transport flange without gas connectors is
mounted because the NightOWL will not fit into the box with gas flange. Watch the position of the flange in
the flight case (recess)