Safety
8
Safety
§
Make sure that all of the permits required for
operation in your country have been obtained
(e.g. the master chimney sweep).
§
Make sure that all standards and guidelines for
operating the device in your country are observed.
§
Never let children play with the foil or other parts of
the packaging.
§
Store the film or other parts of the packaging in a
location which is inaccessible to children.
Safety instructions for the installer
The safety instructions concerning the device's
installation can be found in this section. Additional
safety instructions, concerning the particular actions
and processes, can be found in the respective
chapters.
Ø
Read this chapter carefully before installing the
device.
Ø
Follow all the safety and danger notices during all
activities on the device.
Ø
Only install this device in private kitchens.
Ø
Make sure that the power cable is free from voltage
during installation.
Ø
Check the device and all its parts for visible damage.
In the event of damage, contact your dealer or berbel
customer service. You may only install the device if it
is in perfect working order.
Ø
Mount the device using the supplied brackets only on
load bearing building parts (solid construction).
Ø
Use appropriate fastening mechanisms for any other
sort of installation. If in doubt, please check with the
dealer. Otherwise, you endanger yourself and others.
Ø
Always let qualified specialist personnel conduct
repair work. Otherwise, you endanger yourself and
others.
Avoiding dangers caused by electric shock
§
Only let trained, qualified electricians work on the
power supply.
The electricians must have the following knowledge
and abilities as a minimum:
§
Basic knowledge of electrical engineering.
§
Knowledge of country-specific regulations and
standards (e.g. in Germany, DIN 57100/VDE
0100, part 701).
§
Knowledge of the applicable safety regulations.
§
Knowledge of the relevant legal requirements for
gas installations (e.g. in Germany the technical
rules for gas installations TRGI).
§
Only install the device if it is connected and fused in
accordance with the technical data.
§
Do not kink or crush the electrical power supply
cable.
§
Do not use the device with a damaged electrical
connection cable.
§
In the event of a malfunction, disconnect the device
immediately from the mains.
§
The mains plug must be easily accessible so that
you can quickly and easily isolate the device from
the mains supply in the event of an emergency. If
the mains plug is inaccessible following installation,
an all-pole isolating device with a contact gap of at
least 3 mm must be installed and accessible.
§
If the device is moved from a cold environment into
a hot one, condensation may form inside the
device. In this case wait about 2 to 3 hours before
bringing the device into service.
§
Avoid exposing the device to liquids.
§
Keep the device dry.
Avoiding the risk of explosion
§
Do not install the device in an environment with a
risk of explosion.
Avoiding the risk of fire
§
Make sure that the hob has cooled down before you
cover it.
