Operating
Operating instructions
23
Flashing control indicator: resetting the "change the
recirculated air filter/filling"
In recirculated air mode, you must change the filter
filling after at most 350 hours of operation. After this
amount of operating hours, the "change the
recirculated air filter/filling" control indicator will blink.
The operating hours counter for the "change the
recirculated air filter/filling" control indicator is turned on
or off using this setting.
To reset the indicator after the filter filling has been
changed, and to restart the operating hours meter,
proceed as follows:
Ø
Turn the configuration mode on.
Ø
Briefly touch the touch pad
(power level 3).
The symbol of the touch pad
(power level 3) is
brightly lit and the blinking symbol for the extraction
mode/recirculated air mode function is turned off.
Ø
Turn the configuration mode off.
Setting: turning on the automatic run-on function
As delivered, the automatic run-on function is turned
off.
If you turn on the automatic run-on function, the device
will continue to operate after it has been turned off for a
further ten minutes in the power level that was last set.
Then the device will turn off the ventilation mode.
To turn on the automatic run-on function, proceed as
follows:
Ø
Turn the configuration mode on.
Ø
Briefly touch the touch pad
(power level 4).
The symbol of the touch pad
(power level 4) is
brightly lit.
The function is activated.
Ø
Turn the configuration mode off.
Setting: turning off the automatic run-on function
To turn off the automatic run-on function, proceed as
follows:
Ø
Turn the configuration mode on.
Ø
Briefly touch the touch pad
(power level 4).
The symbol of the touch pad
(power level 4) is dimly
lit.
The function is deactivated.
Ø
Turn the configuration mode off.
