Bennett HIGH FLOW H35, Инструкция по эксплуатации

Страница: 7 / 98

Important Safety Instructions
Bennett HF H35 Instruction Manual 3
IMPORTANT SAFETY INSTRUCTIONS
For safe installation of this equipment, read and understand all dangers, warnings, cautionary, and important information. Save these
important safety instructions in a readily accessible location. Look for the following warnings throughout the manual:
Red and White “DANGER” means: If you do not follow the instructions, severe injury or death will occur.
Orange and Black “WARNING” means: If you do not follow the instructions, severe injury or death can occur.
Yellow and Black “CAUTION” means: If you do not follow the instructions, damage can occur to the dispenser.
Blue and White “ IMPORTANT” means: Helpful tips and other recommendations on equipment installation, usage, and maintenance
should be observed.
DANGER PELIGRO DANGER
•
FIRE, EXPLOSION, INJURY, OR DEATH WILL OCCUR IF FUEL FILTERS ARE CHANGED BY UNTRAINED PERSONNEL.
MAKE SURE, ONLY TRAINED PERSONNEL CHANGE FILTERS.
•
TO PREVENT INJURY TO YOU FROM VEHICLES AND ONLOOKERS; WEAR PERSONAL PROTECTIVE EQUIPMENT
AND ALWAYS PLACE A BARRIER AROUND THIS EQUIPMENT BEFORE PERFORMING SERVICE OR
MAINTENANCE.
•
HYDROGEN IS FLAMMABLE. NO SMOKING OR OPEN FLAME.
•
HYDROGEN DOES NOT HAVE A DISTINCTIVE ODOR AND IS EXTREMELY COLD
•
DISCONNECT ALL POWER, RELIEVE PRESSURE TO THIS EQUIPMENT, AND ASSOCIATED COMPRESSOR DURING
INSTALLATION, SERVICE, OR ANY MAINTENANCE I.E., CHANGING FILTERS.
WARNING ADVERTENCIA MISE EN GARDE
•
You must have training and wear personal protective equipment in the installation, service, or maintenance of
this equipment (dispenser, pump, console, control box, or submerged pump) before working on it. Maintenance
repairs must be done by authorized personnel only. Warranty work may only be performed by Bennett certified
technicians.
•
To prevent electric shock, keep the electrical parts of the dispenser dry.
•
Electronic components are static sensitive. Use only proper static precautions (e.g. static straps) before working
on the equipment.
•
The emergency shut-off valve (also called the fire valve, shear valve, or impact valve) must be closed when
service or maintenance is performed on this equipment.
•
You must have training in the operation and programming of this dispenser before using it. READ AND
UNDERSTAND THE OPERATION SECTION OF THIS MANUAL.
•
Make sure this equipment is correctly grounded. Failure to do will cause injury or damage equipment or
improper operation. Improper grounding voids the warranty.
•
When anchoring the dispenser, always level the dispenser with shims before bolting to the island. DO NOT shim
the middle of base rails to bolt down the dispenser.
•
If the breakaway is not provided, then one must be installed that will disengage at 150lbs.
CAUTION PRECAUCIÓN MISE EN GARDE
•
Do not drill holes in fuel dispensers. Holes can cause failure of the electronic equipment. THE WARRANTY WILL
BECOME VOID. Use only adhesive backed sign mounting brackets.
•
Dispensers must be installed with a suitable power operated compressor incorporating a provision for expansion
relief, which will relieve at pressures not to exceed 14,000 pounds per square inch. Do not use a line check valve
between the dispenser and operated compressor unless provided with a relief valve.
IMPORTANT IMPORTANTE IMPORTANT
•
All trained technicians must work in accordance with all requirements, standards, and guidelines specified by
the suppliers Environmental Standards® Health, Safety, Security & Environment (HSSE) policies.
Note: Bennett
Pump highly recommends all technicians observe HSSE policies defined by the supplier. Bennett Pump does not
impose any restrictions or additional requirements contained in Environmental Standards® Health, Safety,
Security & Environment (HSSE) policies.