Bennett HIGH FLOW H35, Инструкция по эксплуатации

Страница: 58 / 98

Programming
Bennett HF H35 Instruction Manual 54
MENU CODE 28 – HOW TO SET ROUNDING OR TRUNCATING THE SALE AMOUNT
Menu Code 28 allows the manager or operator to set the dispenser for rounding or truncating the sale amount. The rounding
option is set as the default.
Note : In order to guarantee that the sale display cross-multiplies properly for Weights & Measures,
round the Sale Amount.
•
0 - Truncating the Sale Amount
•
1 – (Default) Rounding the Sale Amount
PROGRAMMING PROCEDURE
1. Press the number 2 and 8 , then the [ MODE ] button on the keypad.
The PPM display shows the dispenser is in Menu Code 28. If the
dispenser has not been programmed since it came from the
factory, the number 1 appears in the main display. This is the
default setting as shown in
3.43 .
2. To change the setting, use 0 or 1 button on the keypad to enter a
new option. Note: If an error is made, press the correct number.
The new number will replace the error.
3. When the correct option number appears in the main display,
press the [
ENTER ] button to save the selection.
4. Press the [ CANCEL ] button to exit this Menu Code.
Figure 4.46 – Rounding Sale Amount
MENU CODE 29 – HOW TO SET THE RESETTABLE ELECTRONIC MASS TOTALS
Menu Code 29 is used to reset the electronic resettable meter totals that accumulate in the dispenser every time a sale is
completed. This resetting feature is accessed through Menu Code 29. Refer to the
How to Operate section, How to Read Electronic
Totals with the Magnetic Reed Switch . The totals in Menu Code 1 are not affected by this mode and will continue to accumulate
totals until there is a RAM memory clear.
Sale $
r o u n d
Kilograms
1
C O d E 2 8