Bennett HIGH FLOW H35, Инструкция по эксплуатации

Страница: 67 / 98

Programming
Bennett HF H35 Instruction Manual 63
PROGRAMMING PROCEDURE
1. Press the number 9 and 4 , then the [ MODE ] button on the keypad.
2. The default value is 15 seconds. Press the numeric buttons on the
keypad to enter the number of seconds desired for the time delay.
Note : The delay may be set from 15 to 999 seconds.
3. Press the [ ENTER ] button to save the new setting. Note: If an error is
made, press the correct number. The new number will replace the error.
4. Press the [ CANCEL ] button to exit this Menu Code.
Figure 4.58 – W & M Timeout Delay
MENU CODE 99 – HOW TO VIEW E-CAL VALUES
This menu code allows the technician to view the E-CAL settings.
PROGRAMMING PROCEDURE
1. Press the number 9 and 9 , then the [ MODE ] button on the keypad. The
PPM display shows the dispenser is in Menu Code 99.
2. Meter Calibration Value
3. Mass Adjustment
4. After you press [ ENTER ] , you will be able to view the E-Cal values for
each product and the Meter Data . Press the [ ENTER ] button to cycle
through the E-Cal values. Note: The values are unique to each meter
and side.
5. Press the [ CANCEL ] button to exit this menu code.
Figure 4.59 – E-Cal Values
Figure 4.60 – E-Cal values
Sale $
C r E d i t
Kilograms
1 5
C O d e 9 4
Sale $
A D 1 A
Kilograms
0 0 0
0 0 0 1
Sale $
0 . 0 0
Kilograms
E c A l 1 A
0 0 0 0 1 A