Belden Grass Valley Kaleido-X, Инструкция по установке и обслуживанию

Страница: 68 / 216

68
Kaleido-X (14RU) Expansion
Expanding Existing Kaleido-X Frames
3 Enter the IP addresses currently used by Frame B .
4 Click Save , and then click Apply settings .
Frame A and Frame B should reboot automatically. If Frame B does not reboot
automatically, perform a hard reboot on Frame B only.
5 Open XAdmin, using what is now the expansion system IP address.
6 Click Status and options .
7 Verify that status information appears for all of the cards on both frames in the
expansion system (see Viewing the Status of an Expansion Frame , on page 75).
8 Check the frame and card statuses to make sure there are no problems or error
conditions. In particular, the Cable crossed and Cable plugged alarms on the KXO-EXP
cards should be normal (green).
Notes
• You may see messages on the monitor wall warning you that KX0 heads
are not assigned. This is normal.
• If one or more cards in a Kaleido Multiviewer frame is being upgraded (i.e.
if a Live Update is in progress), then it is not possible to apply any changes
made in XAdmin. If you click
Apply settings in the XAdmin sidebar, an
error message will appear. This restriction also occurs during the first 10 to
20 seconds after a card is inserted into or removed from the frame. Wait
until the upgrade has finished, and then click
Apply settings again.
Select the check
box to enable
expansion mode
Click here to
view this page
This button
becomes
available after
you click Save.