Belden Grass Valley Kaleido-X, Инструкция по установке и обслуживанию

Страница: 36 / 216

36
Installation
Card Installation in the Kaleido-X Frame
the system may later become the master (for example, when you remove or reseat this card
from Frame A Output C).
To install a dual channel HD-SDI monitoring mezzanine on a KXO-Dual or KXO-Dual3
module, refer to
KXO-HDM Installation Instructions . See Related Documentation
, on page 15
.
Every output card is connected to the other cards in the Kaleido-X frame through the
frame’s internal midplane. See External connections to the card are made through
connectors that are found in the following locations:
• on the rear panel (see KXO-Dual Output Rear Panel Connections , on page 82)
• on the front card edge (see KXO-Dual Ouput Card Front-Edge Description , on page 29)
GPI/Genlock Card Installation
The GPI/Genlock card fits in the Kaleido-X frame. It is complemented by a rear panel
connector KXA-GPI-GEN-R that houses all input and output connectors associated with the
card.
The GPI/Genlock card must be installed in the MAIN slot in the Kaleido-X frame. This slot is
color-coded GREY on the front and rear panel of the frame.
The GPI/Genlock card is connected to the other cards in the Kaleido-X frame through the
frame's internal midplane. See
Card Installation and Replacement on page 161, for
instructions on installing the card and the rear panel.
External connections to the card are made through the card’s corresponding rear panel. See
GPI/Genlock Rear Panel Connections , on page 83.
Notes
• The rear panel must be installed at the rear of the frame before the card is
installed.
• Be careful to install the rear panel in the matching location at the rear of
the frame.
• These cards are hot-swappable; it is not necessary to turn off the Kaleido-
X when installing or replacing cards.
• If a software master card loses network connectivity while remaining
seated in its slot, then none of the other cards will take over and the
multiviewer will be unavailable on the network until the connectivity
issue is resolved.
Notes
• The rear panel must be installed at the rear of the frame before the card is
installed.
• Be careful to install the KXA-GPI-GEN-R rear panel in the matching location
at the rear of the frame.
• Kaleido-X cards are hot-swappable; it is not necessary to turn off the
multiviewer when installing or exchanging cards.