Belarus 1221.2, Руководство оператора

Страница: 37 / 295

BELARUS-1221.2/1221 В .2/1221.3 Operating controls and instruments
36
HG5 is the indicator of switching on the upper beam of the road headlights; it lights up
when the upper beam of the road headlights is ON.
Note! The indicators light up and go out synchronously with the changes in the states of
the system sensors.
Indicator control board
РЕЖИМ – MODE
ЗНАЧЕНИЕ – VALUE
ПАРАМЕТР - PARAMETER
The programming board makes it possible to perform the manual programming of
the combined indicator by means of the “Parameter” ( Параметр ) and “Value” ( Значе-
ние ) buttons and to modify the mode of display of the parameters to be shown on the
LCD.
The diagnostic connector ХР1 located on the front panel of the control board makes
it possible to perform the automatic programming (reprogramming) of the CI by means
of a special instrument (if provided). Should such an instrument be unavailable, the pro-
gramming shall be performed by means of the above buttons.
1.10 CI programming procedure
1. On selecting the fixed value of the programming parameter:
1.1. On pressing the “Parameter” (Параметр) button for the first time, the LCD is
switched to the mode of viewing the parameter to be programmed and its numerical
value. On pressing this button repeatedly, the parameters are switched over cyclically.
1.2. On pressing successively the “Parameter” button, the numerical value of the set pa-
rameter to be programmed changes.
1.3. The mode is exited automatically if neither “Parameter” (Параметр) nor “Value”
(Значение) button has been pressed within 7.0 sec.
On exiting the mode, the last values of the parameters selected by the “Value”
(Значение) button are saved.
2. When entering the unfixed value of the programming parameter:
2.1. Select the parameter, the values of which shall be set, by means of the “Parameter”
(Параметр) button;
2.2. Press twice the “Mode” (Режим) button; the least digit of the numerical value starts
blinking;