Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
BACTEC®
9050
System User's Manual
Figure 31 - Floppy Disk Drive Pin 1 Identification (typical)
7 B e f o r e attaching the flat ribbon cable, you must identify Pin I on the disk
drive. Locate the cable socket on the drive assembly. Locate the pins on the
printed circuit board that correspond to the pins of the cable socket. Lo-
cate the Pin I designation (marked by white number "I ") on the printed
circuit board (not the connector). Align the dark blue strand o f the flat
ribbon cable with Pin I o f the printed circuit board, and plug in the cable.
Note that in most cases, the dark blue strand will be oriented at the center
of the board. However , this orientation can vary among different disk drive
manufacturers. It is important to verify the location of Pin I on the drive's
pc board. If necessary, you can peel the plastic shield away from the disk
drive (as shown in Figure 31) to see better.
.3 I n s e r t the new drive/bracket and tighten the fasteners.
72
MA-0103-F3
Artisan Technology Group - Quality Instrumentation ... Guaranteed I (888) 88-SOURCE I www.artisantg.com