Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
I3ACTEC®
9050
System User's Manual
6.3.3.14 Power Supply (40V)
Board
The 40V Power Supply is located at the top of the right electronics compart-
ment, toward the rear of the instrument. (The 5V/± I 5V Power Supply is right
next to this board, toward the front of the instrument.) To replace the 40V
Power Supply, follow the steps below and refer to Figure 49.
Required Materials
' V Hex Nut Driver
To
Replace
the Power Supply Board
I R e m o v e the rear cabinet shell as described in Section 6.3.3.1.
2 R e m o v e the Electrical Guard as described in Section 6.3.3.2.
3 U n p l u g the white connector on the top of the board.
4 U n p l u g the connector on the bottom of the board.
5 T h e r e is one nut on each of the board's four corners. Remove these nuts
and remove the board.
6 R e p l a c e the board by reversing the above steps.
•
Figure 4 9 - Power Supply (40V) Removal
94
MA-0103-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed I (888) 88-SOURCE I www.artisantg.com