* If the hand control is flashing, reset the system by simultaneously pressing
the two top buttons on the hand control. You will hear 10 rhythmic beeps.
Press and hold the buttons until the beeping stops.
The
The
button works
button works
as a stop button
as a stop button
Tighten the sheet on
the red bar
Slacken the sheet
on the red bar
Raise
the red bar
Lower
the red bar
Raise
the blue bar
Lower
the blue bar
Tighten the sheet on
the blue bar
Slacken the sheet
on the blue bar
Speed Adjustment
Flash light
Reset*
Power w.
illuminated diode/
stop
VENDLET must be used
and installed in accordance
with the manual
QUICK GUIDE
Ver
s. 1.0 - Oct
ober 2020
4. If it is estimated that the bedridden must use side rails, raise the bars.
Slacken the sheet.
5. If it is estimated that the bedridden should not use side rails, lower the bars.
Slacken the sheet.
Scan the QR
code to watch
instruction
videos
VEND
LET
Standard
Always, keep focus on the client when using VENDLET.
1. Elevate the bed to the right working height.
2. Double-click the button to activate the VENDLET system. The VENDLET
system produces an acoustic signal and the green diode over the power
symbol turns on. When the hand control has been inactive for 90 seconds,
the system is off again.
3. The patient is repositioned by operating the hand control.
THE USE
Reset*
+45 9631 0050 [email protected] www.vendlet.dk
