Baumuller b maXX 5500, Инструкция по эксплуатации

Страница: 70 / 316

Electrical data basic units
Instruction handbook b maXX BM5500, BM5600, BM5700
Document No.: 5.13008.10 Baumüller Nürnberg GmbH
70
of 314
3.4
1)
All rated values refer to a DC link voltage of 540 V, a control voltage of 24 V and an environmental temperature of 40 °C.
2)
Using the power choke listed in Z Power chokes – from page 288 at a power supply with U
K,power supply
= 0.4 %.
3)
The output voltage is a pulsed DC voltage. The operating range refers to the RMS of the fundamental wave.

U
AC
3 0 V to

3
U
DC
2
-----------
10 V
–
 
 

=
without overmodulation of the PWM.
4)
Switching frequency of the inverter (adjustable).
5)
RMS at an environmental temperature of 40 °C.
6)
At rated power supply voltage the unit supplies rated / maximum output currents. With input voltages above the rated power supply
voltage the output currents must be reduced at constant output power.
Out
put cu
rrent
[%]
Derating of output current
BM5X32, BM5534
Power supply voltage [V]
Out
put cu
rrent
[%]
Derating of output current
BM5533; BM5535
Power supply voltage [V]
Figure37: Derating the output current BM553X universal units
7)
The input current must be reduced between 40 °C and 55 °C. Refer to correction factors at changed operating conditions Z Environ-
mental temperature – on page 55.
8)
The possible overload time at this moment is dependent of the device load and the heat sink temperature. The device load is determined
by the overload monitoring of the device.
9)
The sum of the mean effective power, which is transmitted via the DC link terminals and the mean effective power at the motor terminals,
may not exceed the specified value continuously.
10)
The range of the output frequency is based on a stationary operation in the linear range of the PWM, i. e. without overmodulation.

The quality of the generated output voltages depends on the ratio between output frequency and current controller frequency f
I-R

( f
I-R
= 1/cycle time current controller).

The maximum output frequency f
max
, generated with high quality, is calculated as follows:


f
max
f
I-R
K
pf
--------
, typical K
Pf
18

=


Furthermore the controller sets an upper limit for the output frequency of 599 Hz (please contact the responsible Baumüller sales de-
partment, keyword: export restriction).

The range of the output frequency is defined as follows:
PWM frequency Current controller cycle time Range of the output frequency
2 kHz 250 µs 0 - 225 Hz
4 kHz 125 µs 0 - 450 Hz
8 kHz 62.5 µs 0 - 599 Hz (900 Hz
*)
)

*)
900 Hz could be generated by the controller

The device is able to generate output voltages with frequencies between f
max
and 599 Hz and the controller allows that, however the
quality of this voltages cannot be guaranteed.

Typical the devices are marked with the max output frequency at 4 kHz switching frequency: 0 ... 450 kHz.
11)
At maximum 4 A if UL508 C is complied with.