Barudan BENS, Руководство по эксплуатации

Страница: 97 / 103

DISPLAYED MEANING ACTION REQUIRED
D26 Is fan moving? The pantograph drive mo-
tor is overheating or in an
overcurrent condition.
Turn power off and let machine
cool down. Make sure fan and
driver unit work properly. Check
that nothing blocks fan ventila-
tion. If error occurs again, con-
tact a service technician.
D27 Temporary
Repair Stop
Sewing has been stopped
because the machine en-
countered a temporary re-
pair stop signal that was
inserted in the previous
run of this design.
Turn on the head that was
turned off in the previous run,
then move the start/stop bar to
the left to continue sewing. See
the Operation Guide for informa-
tion on temporary repair stops.
D28 Cannot Backup
past Color
Change
The machine cannot con-
tinue backing up past the
color change, unless you
execute a manual trim.
Execute a manual trim. Then
continue backing up to the re-
quired point.
D29 Seek Origin Displays when you turn on
the machine.
Press the Execute icon to let the
machine seek origin.
D30 Head Control
Board Error
An error has occurred with
the Head Control board.
Contact a service technician.
D31 Driver Error Communication error be-
tween the automat and
driver unit.
Check that the 25-pin cable be-
tween the automat and driver
unit is seated properly on both
ends. If error reoccurs, contact a
service technician.
D32 Sub End There is an SE function
code in the design.
To use the manual Roll to Roll
feature, release the fabric
clamps then move the start/stop
bar to the left. The needle stays
down in the fabric while the pan-
tograph moves back to the
design’s origin point. After re-
placing the fabric clamps you
can continue sewing, creating a
long panel of embroidery.
BENS Operation Guide - 12/99 Error Codes 4-7