Barudan BENS, Руководство по эксплуатации

Страница: 73 / 103

Changing the Origin
1. If you were sewing, move the Start/Stop
bar to the right, to stop.
2. Use the jog keys to move the
pantograph to the new position.
3. Press and hold both B and C for
approximately 5 seconds.
In the values box, the ABS values are
shown with a darker box, letting you
know the origin has changed.
4. Move the Start/Stop bar to the left or
press the Start button to begin sewing at
this point.
Note that the start point of the design
will have been changed by the distance the pantograph was moved
with the jog keys.
Standby
Standby lets you resume operation of the
machine when sewing at the time of a power
failure or if the machine has been turned off
before sewing was completed.
Using Standby
1.
Power on the BENS. The following
screen displays.
NOTE: If the machine shut off because it
moved beyond a frame limit, you will need to push the pantograph back
within the limits before powering on. At the Origin Set screen, you must
press A for five seconds to bypass seeking origin. Seeking origin at this
point would move back to the frame limit, shutting off the machine
again.
NOTE: If the machine shut off due to power failure, and the needle
remained in the fabric, you will need to execute a manual thread trim, to
raise the needle before moving the pantograph, to avoid damage to the
machine.
3-10 Sewing BENS Operation Guide - 12/99
Standby Screen
Power On Screen