Barudan BENS, Руководство по эксплуатации

Страница: 71 / 103

exit Drive and move the pantograph to a different start point. See the
Mechanical Guide for information on soft limits.
Sewing from Memory
1. Press the Memory softkey. The Pattern List displays.
2.
Use the jog keys to select the pattern you want to sew.
3. Press the Memory softkey again to close
the Pattern List.
NOTE: You can also simply press the
origin key (in the center of the jog keys)
to close the list and move the pantograph
to the start point (as recorded the last
time that pattern was placed in Drive
mode).
4. Use the jog keys to position the
pantograph at the desired start point for
the pattern.
5.
Press the Drive softkey. The light above
the key stops blinking and lights
steadily, indicating that the machine is
in Drive mode.
6. Press D, below the Perimeter Trace icon, to make sure that the
pattern will be sewn in the desired position on the fabric.
CAUTION! Make sure the needle is up, out of the fabric, before using
perimeter trace, to prevent damage to the machine.
NOTE: If you need to change the pattern’s
start position at this point, you must exit
the Drive mode. If you move the
pantograph with the jog keys while in Drive
mode, this movement is ignored. When you
begin sewing, the pantograph moves back
to the origin set when you entered Drive
mode.
To exit Drive mode, press and hold the
Drive softkey until the machine beeps and
the Drive light is blinking. Then use the jog
keys to move to the correct position, and
press Drive again.
3-8 Sewing BENS Operation Guide - 12/99
Drive
Softkey
Drive Screen
Memory
Softkey