Barudan BENS, Руководство по эксплуатации

Страница: 37 / 103

3. The icon at the top left of the
screen identifies the active device.
It should show the COM-In icon,
indicating communication through
the COM port. If this is not the
current icon, press A, below the
Device icon, until it displays at the
top left. Pressing A toggles through
the device options, Disk, Tape,
COM and Jog.
The BENS automatically identifies
the next empty memory location,
where the pattern will be stored.
This number, shown in the middle
left of the screen, flashes.
NOTE: You can also save to an
occupied memory location, adding
to an existing pattern. See page
2-21 for instructions.
4.
The letter to the right of the device
icon identifies the Tape code. If
necessary, press B, below the
Code icon, to select the
appropriate code. Pressing B
toggles through the three code
options: U, F, and El.
5. Press D, below the Execute icon
to transfer from paper tape. To exit
without reading in a pattern, press the Read softkey. The display shows
a count of the stitches as they are transferred.
•
To stop the transfer, press D, below the Pause icon.
•
Press D again to resume. Press C, below the X icon, to cancel.
When complete, the BENS beeps and the basic screen displays.
2-6 Memory Operations BENS Operation Guide - 12/99