Barudan BENS, Руководство по эксплуатации

Страница: 35 / 103

Reading a Pattern through the Tape Connection
1.
Connect the tape reader to the BENS tape port and load the paper
tape, following the instructions in the tape reader’s user manual. See
page 1-23 for instructions on connecting tape readers to the BENS.
2.
Press the Read softkey. The floppy disk list displays.
If there is not a disk in the disk drive, and Disk was the last device
used, error A30 displays. Press any
menu key to clear the message,
then proceed with Step 3.
3.
The icon at the top left of the
screen identifies the active device.
It should show the Tape icon,
indicating communication through
the tape reader port. If this is not
the current icon, press A, below
the Device icon, until it displays at
the top left. Pressing A toggles
through the device options, Read,
Tape, COM and Jog.
The BENS automatically identifies
the next empty memory location,
where the pattern will be stored.
This number, shown in the middle
left of the screen, flashes.
NOTE: You can also save to an
occupied memory location, adding to
an existing pattern. See page 2-21 for
instructions.
4.
The letter to the right of the device
icon identifies the tape code.
•
If necessary, press B, below the Code icon, to select the appropriate
paper tape code. Pressing B toggles through the three code options:
U, F and El.
2-4 Memory Operations BENS Operation Guide - 12/99
Read
Softkey