Baldor VS1GV21-1B, Инструкция по установке и эксплуатации

Страница: 159 / 204

Technical Specifications A-3 MN765
Differential
Analog Input
Common Mode Rejection 40 db
Full Scale Range ±5VDC, ±10VDC, 4-20mA and 0-20mA
Resolution 11 bits + sign
Input Impedance 80 kOhms (Volt mode); 500 Ohms (Current mode)
Single Ended
Analog Input
Full Scale Range 0 - 10VDC
Resolution 11 bits
Input Impedance 80 kOhms
Analog Outputs
Analog Outputs 2 Assignable
Full Scale Range AOUT1 (0-5V, 0-10V, 0-20mA or 4-20mA), AOUT2 (±5V, ±10V)
Source Current 1mA maximum (volt mode), 20mA (current mode)
Resolution 9 bits + sign
Digital Inputs
Opto-isolated Inputs 8 Assignable, 1 dedicated input (Drive Enable)
Rated Voltage 10 - 30VDC (closed contacts std)
Input Impedance 4.71 kOhms
Leakage Current 10 µA maximum
Update Rate 16 msec
Digital Outputs
(2 Opto Outputs)
Rated Voltage 5 to 30VDC
Maximum Current 60mA Maximum
ON Voltage Drop 2VDC Maximum
OFF Leakage Current 0.1A Maximum
Output Conditions 31 Conditions (see Output Setup Block parameter table, Chapter 7)
Digital Outputs
(2 Relay Outputs)
Rated Voltage 5 to 30VDC or 240VAC
Maximum Current 5A Maximum non-inductive
Output Conditions 31 Conditions (see Output Setup Block parameter table, Chapter 7)
Diagnostic Indications
:
Current Sense Fault Regeneration (DB) Overload Following Error
Ground Fault Soft Start Fault PWR Base Fault
Instantaneous Over Current Under Voltage Logic Power Fault
Overload Ready Encoder Loss
Line Power Loss Parameter Loss
Microprocessor Failure Overload
Over temperature (Motor or Control) Overvoltage
Over speed Torque Proving
Note: All specifications are subject to change without notice.
Table A-1 VS1GV Specifications Continued