Baldor VS1GV21-1B, Инструкция по установке и эксплуатации

Страница: 10 / 204

1-4 Introduction MN765
Figure 1-1 Minimum Connection Diagram
Example of Terminal Strip Layout
Input AC
Power
Earth Ground
DB Resistor
(Internal)
GND TH2 TH1 T3 T2 T1 B- R2
R1/B+
L3 L2 L1
G
T3
T2
T1
TH2
TH1
Motor
Motor Leads
Motor Thermal
Leads*
Fuses
AC Power & Motor Connections
Minimum Signal Connections
Terminals 1 to 7 (J1)
1 User Analog Return
2 Analog Input #1
3 Analog Ref. Power
4 Analog Input #2 +
5 Analog Input #2 -
6 Analog Output #1
7 Analog Output #2
Terminals 8 to 20 (J2)
8 Enable Input
9 Digital Input #1
10 Digital Input #2
11 Digital Input #3
12 Digital Input #4
13 Digital Input #5
14 Digital Input #6
15 Digital Input #7
16 Digital Input #8
17 Digital Out #1+ (Collector)
18 Digital Out #1- (Emitter)
19 Digital Out #2+ (Collector)
20 Digital Out #2- (Emitter)
For keypad operation, only Enable (J2-8) is required.
J1
J2
J3
USB Port
1
8
21
Terminals 21 to 30 (J3)
21 External User +24V Return
22 External User +24V
23 In24V
24 In24V Return
25 Relay Out 1 NC
26 Relay Out 1 COM
27 Relay Out 1 NO
28 Relay Out 2 NC
29 Relay Out 2 COM
30 Relay Out 2 NO
GND
**
Note:
The control enable input must be active to allow operation. Therefore, J2-8 Enable is connected by a factory installed
jumper to J3-24. This uses the internal supply and provides an active low at J2-8.
* Remove TH1 and TH2 jumper if Motor Thermal Leads are connected.
Note:
Motor thermal leads must be run in a separate conduit from motor power leads.
Note: An open circuit on these terminals will generate a motor overtemperature fault. Refer to the fault / troubleshooting
information provided in Chapter 9.
** See Figure 4-3 for terminal arrangement for the various frame sizes.