Baldor VS1GV21-1B, Инструкция по установке и эксплуатации

Страница: 100 / 204

7-22 Parameter Descriptions MN765
Block Title Parameter (Number)
Selection (Value)
Parameter Name and Description
MISCELLA-
NEOUS
(Continued)
HOMING OFFSET (2308)
Only available or active in Closed
Vector mode. Ignore for Open
Vector and V/F modes.
Preset Value: 1024
Range: -9999 to 20000 counts
This parameter sets the number of quadrature encoder counts past home at
which the motor will stop. Quadrature encoder pulses are 4 times the number
of encoder lines per revolution. The recommended minimum number is 100
encoder counts to allow for deceleration distance to allow the motor to stop
smoothly. Example: Encoder resolution is 1024 lines per revolution. The motor
must stop one complete revolution past the home marker position. Therefore:
Homing Offset = (1 Revolution) X (4 X 1024 lines per Rev.) = 4096 quadrature
counts. Note: Homing direction always begins in the drive forward direction.
The shaft will continue to rotate in either direction to the user defined ±offset
value (P2308).
FILTER TYPE (2309) Preset Value: 0
Range: 0 - 3
None (0) Sets the auxiliary filter to None.
Low Pass (1) Sets the auxiliary filter to Low Pass.
High Pass (2) Sets the auxiliary filter to High Pass.
Notch (3) Sets the auxiliary filter to Notch.
FILTER SOURCE (2310) Preset Value: 0
Range: 0 - 9
None (0) Sets the auxiliary filter to None.
Raw Speed (1) Sets the auxiliary filter to Raw Speed.
Torque (2) Sets the auxiliary filter to Torque Loop.
Analog In1 (3) Sets the auxiliary filter to Analog In1.
Analog In2 (4) Sets the auxiliary filter to Analog In2.
Composite Ref (5) Sets the auxiliary filter to Composite Reference.
Opt1 Ana In1 (6) Sets the auxiliary filter to Opt1 Ana In1.
Opt1 Ana In2 (7) Sets the auxiliary filter to Opt1 Ana In2.
Opt2 Ana In1 (8) Sets the auxiliary filter to Opt2 Ana In1.
Opt2 Ana In2 (9) Sets the auxiliary filter to Opt2 Ana In2.
FILTER DEST (2311) Preset Value: 0
Range: 0 - 6
None (0) Sets the Filter Destination, (Output), to None.
Speed Loop (1) Sets the Filter Destination, (Output), to Speed Loop.
Torque Loop (2) Sets the Filter Destination, (Output), to Torque Loop.
Speed FFWD (3) Sets the Filter Destination, (Output), to Speed Forward.
Process FBK (4) Sets the Filter Destination, (Output), to Process Feedback.
Process FFWD (5) Sets the Filter Destination, (Output), to Process Feedforward.
Process SP (6) Sets the Filter Destination, (Output), to Process Setpoint.
FILTER CUTOFF (2312) Preset Value: 0.00
Range: 0.00 - 1000.00 Hz
Sets the cutoff frequency of the auxiliary filter (a low value = slower response).
NOTCH CNTR FREQ (2313) Preset Value: 0.00
Range: 0.00 - 500.00 Hz
Sets the center frequency for the notch filter (if Filter Type=Notch).
NOTCH BAND
(2314) Preset Value: 0.00
Range: 0.00 - 200.00 Hz
Sets the frequency band of the notch filter (if Filter Type=Notch).
Table 7-2 Level 2 Parameter Block Definitions Continued