Baby Lock Enterprise BNT10L, Инструкция и справочник

Страница: 291 / 312

Troubleshooting 289
7
—————————————————————————————————————————————————————————————————————————————————————
The upper thread
breaks.
Adhesive is attached to the
needle.
Replace the needle. p.88
The fabric is not taut.
Firmly set the fabric in the
embroidery frame so that it is
taut.
p.49, 94
The thread quality is poor.
The thread quality is too weak
due to age of thread. Replace
thread.
The embroidery data contains
stitches with a stitch length of
zero.
Delete all stitches with a zero
stitch length.
p.224
The embroidery data contains
many stitches with an extremely
small stitch length.
Delete all stitches with a small
stitch length.
p.224
The thread density of the
embroidery data is too fine.
Three or more overlapping
stitches are being sewn.
Using a data design system,
correct the thread density and
overstitching settings in the
embroidery data.
p.150
The bobbin
thread breaks.
The bobbin thread is not
correctly threaded.
Correctly thread the bobbin
thread.
p.38
The bobbin is scratched or does
not rotate smoothly.
Replace the bobbin. p.38
The bobbin case is damaged. Replace the bobbin case. p.38
The thread is tangled.
Remove the thread jammed
and clean the hook.
p.277
A bobbin designed specifically
for this machine is not used.
Use the correct bobbin. p.35
Stitches are
skipped.
The upper thread is not
threaded correctly.
Thread the upper thread
correctly.
p.56
The needle is bent or blunt.
Replace the needle with a new
one.
p.35, 88
The needle is not installed
correctly.
Correctly install the needle. p.88
Dust has accumulated under the
needle plate or in the hook.
Clean the hook and the needle
plate.
p.277, 278
The needle and the hook are not
correctly passing each other.
Consult your nearest Baby Lock
retailer.
The thread twist is either too
tight or too loose.
Improper twisting results in
irregular loop formation. Try
using a new spool.
The embroidery
pattern is
misaligned.
The thread is tangled.
Use tweezers to remove any
tangled thread from the hook.
The fabric is not secured in the
embroidery frame (for example,
the fabric is not taut).
If the fabric is not taut, the
pattern may become
misaligned or the stitching may
shrink. Be sure to correctly
frame the fabric in the
embroidery frame.
p.49, 94
The embroidery frame is too
large for the size of the
embroidery.
Use an embroidery frame that
is close to the size of the
embroidery.
p.90
Stabilizer (backing) is not used.
Use stabilizer (backing) when
embroidering on thin or stretch
fabrics, fabrics with a coarse
weave or fabrics that easily
allow the stitching to shrink.
<When using the optional cap
frame>
Use hard stabilizer when
embroidering on a cap made of
soft material.
p.93
Symptom Probable Cause Remedy Reference Page