Baby Lock Enterprise BNT10L, Инструкция и справочник

Страница: 293 / 312

Troubleshooting 291
7
—————————————————————————————————————————————————————————————————————————————————————
There are loops in
the upper thread.
Thread is not correctly threaded
around upper thread tension
discs.
Clean upper thread tension
disc. Rethread and make sure
tension disc rotates when
pulling on thread.
p.281
The thread quality is poor.
Try sewing with different
thread. If the problem no
longer occurs after the thread is
changed, the thread quality is
the problem. Replace the
thread with one of good
quality.
The machine is
noisy.
Lint may be wound in the hook. Clean the hook. p.277
The upper thread is not
threaded correctly.
Check the thread path, and
then thread the upper thread
again.
p.56
The hook is damaged.
Replace the hook.
Consult your nearest Baby Lock
retailer.
Not enough oil was applied. Oil recommended parts. p.282
The needle
threader cannot
be used.
The needle is not at the correct
position.
Touch the key to move the
desired needle bar to be
threaded into embroidering
position.
p.63
Recommended needles are not
used on this machine.
Replace and use recommended
needle.
p.35, 88
The needle is not installed
correctly.
Correctly install the needle. p.35, 88
The hook on the automatic
needle-threading mechanism is
bent.
Consult your nearest Baby Lock
retailer.
p.35, 88
The thread
tension is
incorrect.
The upper thread is not
threaded correctly.
Check the thread path, and
then thread the upper thread
again.
p.56
The bobbin thread is not
correctly threaded.
Correctly thread the bobbin
thread.
p.38
The lower thread tension is
incorrect.
Adjust the tension of the
bobbin thread.
p.122
The upper thread
comes out of the
needle when
embroidering
begins.
If a short length of thread
remains after the thread is
trimmed, the needle may
become unthreaded when
embroidering begins again.
Set the remaining length of
thread to “Long Tail” on the
second page of the settings
screen.
p.225
The upper thread
does not reach
the bobbin thread
when
embroidering
begins.
There is no more thread in the
bobbin, the thread does not
feed from the bobbin, or the
thread that is fed from the
bobbin is too short.
Correctly thread the lower
thread.
p.38
Although the
thread is not
broken, a broken
thread error
occurs and the
machine stops.
If the thread breakage sensor in
the thread tension disc of the
thread tension knobs cannot
detect that the thread is being
fed, even if the machine is
running, a broken thread error
occurs and the machine is
stopped. If the thread came out
of the thread tension disc, even
though the thread is not broken,
the machine detects that the
thread is not being fed and stops.
Clean the tension unit.
Correctly pass the thread
through the thread tension disc.
If the broken thread error
occurs after the machine is
cleaned and rethreaded, the
sensor may be damaged.
Consult your nearest Baby Lock
retailer.
p.58, 281
Symptom Probable Cause Remedy Reference Page