Azbil F4Q, Руководство пользователя

Страница: 32 / 76

4-16
Chapter 4. CPL Communication
The following table shows termination codes.
Termination
code
Type Description Note
00H Normal Normal termination -
10H Error There was an error in the
data address or the number
of data records. The data cannot be converted to a number, “W” is not set, the
position of the comma is incorrect, etc.
13H Error Error in execution An error occurred during writing or reading.
40H Error There was an error in the
number of data records to
access. The number of data records to be read or written is not from 1
to 10.
43H Error Write error Unsupported write data address, out-of-range data, writing
under read-only conditions, etc.
98H Error System error Memory access failure, etc.
99H Error Undefined command Or other message error
Handling Precautions
•
The success of writing when an error response is returned cannot be
guaranteed. If an error occurs during consecutive data writing, the data may
have been updated halfway. Be sure to write the data again with a correct
message.
4 - 4 Termination Code