Avaya programming and use, Инструкция по установке и эксплуатации, Страница: 70 / 468

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Installing Telephones
2-38
Connecting and Testing Telephones
2
9. Remove the plastic cover from the telephone
(see
Figure 2-34 ). Label the button sheet to
show any programmed lines or button features.
Then place the button sheet on the telephone
so the holes fit over the buttons. Carefully
replace the plastic cover.
10. Make sure the swivel display is set to the
lowest position.
Figure 2-34. Removing the Plastic
Cover
Follow these steps to connect and test a telephone:
1. To connect a telephone, plug the modular
telephone mounting cord into a modular wall
jack or directly into a module extension jack
(see
Figure 2-35 ).
2. Test the power and lights on a system
telephone:
a. While the telephone is idle, press and hold
the
#
button for five seconds.
b. Before releasing the
#
button, lift the
handset.
All lights should light, the ringer should
sound, and (on system display telephones
only) a test pattern should appear on the
display. If these do not occur, call for
support as instructed on the copyright page
of this guide.
c. Replace the handset; the telephone is now
in normal operating mode.
Figure 2-35. Plugging in Telephone
Cords
To install two telephones (or other
devices) on a single extension jack,
see
“Combination Extensions” on
page 9-3 .
L
I
N
E
S
PFT
E
X
T
E
N
S
I
O
N
S
PFT
4
5
23
18
19
20
21
22
MODULE
206
L
I
N
E
S
PFT
E
X
T
E
N
S
I
O
N
S
PFT
6
7
24
25
26
27
28
29
MODULE
206
Transfr
Feature
Intercom
ABC
2
DEF
3 1 +
–
Conf
JKL
5
MNO
6
TUV
8
WXYZ
9
Mic
HFAI
Hold
0
GHI
4
PQRS
7
*
# Spkr
Intercom
Ext. Message
1
2
3
10
11
12
14
15
16
17
13