Avaya programming and use, Инструкция по установке и эксплуатации, Страница: 244 / 468

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Auto Dialing
8-6
Programming
8
To program an Auto Dial button:
1. Press
f00
.
2. Press a programmable button.
3. Enter an account code, PBX/Centrex feature access code, or one of the following:
■
Outside telephone number. Enter the telephone number (up to 28 digits) exactly as you
would dial it.
■
Extension number. Press the left
i
button, and enter the two-digit extension
number. Press
*
before the extension number to program the Auto Dial button to voice-
signal an extension. For example, to program extension 20 for voice signaling, press
i20
.
■
Feature code. Enter the appropriate code. For example, to program a button to turn on the
message light at extension 20, press
f0920
. When you press the programmed
button, the message light at extension 20 turns on.
4. Repeat Steps 3 and 4 to program additional Auto Dial buttons, or exit programming mode.
Using Auto Dialing
8
From a system telephone, to dial an outside number or extension number (you can lift the handset
or press
S
, but you do not have to do so):
1. Do one of the following:
■
If you want to call on a specific line, press the line button (or press
i8
and dial the
two-digit line number).
If you did not lift the handset, the lights next to
S
and
!
go on, and you are active
on the speakerphone.
■
If you want to call by using a specific pool on a pooled extension, press the pool button (or
press
i
and dial the three-digit pool access code).
If you did not lift the handset, the lights next to
S
and
!
go on, and you are active
on the speakerphone.
2. Press the Auto Dial button on which the outside number or extension number is programmed.
The system automatically selects a line if you did not specify one, turns on the speaker (if you
did not lift the handset), and dials the Auto Dial number. The number being dialed appears on
a display telephone.
To use an Auto Dial button programmed with a feature code or account code, follow the directions
for the feature you want to use.