Avaya programming and use, Инструкция по установке и эксплуатации, Страница: 386 / 468

PARTNER
®
Advanced Communications System Installation, Programming, and Use
Changing Settings and Adding Lines, Pools, and Extensions
10-20
If you add an outside line to your system for use in an existing pool, use Dial Mode (#201) if the
new line is a rotary line and Pool Line Assignment (#207) to add the line to an existing pool.
Adding New Pools
1 0
You can create new pools if your system is operating in Hybrid mode. If you add outside lines for
use in a new pool, you may need to use the following features:
■
Dial Mode (#201) if the new lines are rotary lines
■
Pool Line Assignment (#207) to assign lines to the new pool
■
Pool Extension Assignment (#314) to assign the new pool to specific extensions
■
Line Ringing to specify when the new pool starts ringing at each extension that has the pool
■
Pool Access Restriction (#315) to limit an extension’s access to all the lines in the new pool
■
Automatic Line Selection to add the new pool to the extension’s Automatic Line Selection
sequence
Adding New Extensions
1 0
If you add an extension to your system, you can probably use Copy Settings (#399) to copy the
settings of an existing extension. If you wish to further adjust a new extension’s settings, see
“Customizing Extensions” on page 3-16 .
Swapping Extensions
1 0
If a user changes location but wants to keep the same extension number, you can make the
change easily by changing the connection at the control unit.
For example, if the users at extensions 29 and 32 switch offices, you can disconnect the modular
plugs from those extension jacks in the control unit. Then reconnect the plug from 32 into
extension jack 29 and the plug from 29 into extension jack 32. Now the users can take their
respective telephones to their new locations, keep the same extension numbers, and retain the
telephones’ programmed settings.
Do not use Number of Lines (#104) if you add lines to the system after initial setup
because it changes Pool Line Assignment (#207), Pool Extension Assignment (#314),
Pool Access Restriction (#315), Automatic Line Selection, and Line Ringing for
existing pools back to factory settings. Additionally, it changes Line Assignment (#301),
Line Access Restriction (#302), Automatic Line Selection, and Line Ringing for
individual lines back to factory settings. To change pool assignments without affecting other
settings, use Pool Line Assignment (#207) and Pool Extension Assignment (#314).