Avaya programming and use, Инструкция по установке и эксплуатации, Страница: 173 / 468

Initial Telephone Programming
Automatic Line Selection
5-3
If a single-line telephone user intends to place intercom calls and access system features,
Automatic Line Selection for his or her extension should be set to intercom first for proper
operation. For example, the setting for a single-line telephone in a lobby used for internal calling or
making local calls on Line 1, would be “Intercom, 1.”
Considerations
5
■
If Forced Account Code Entry (#307) is assigned to an extension, Automatic Line
Selection for that extension does not apply. This means the user must manually select a line
or pool after entering a required account code.
■
For an extension identified as a Hotline (#603) or Doorphone Extension (#604/#605),
program the extension to select only the intercom, with no outside lines in the selection
sequence.
■
For an extension identified as an External Hotline (#311), program the extension to select
outside lines or pools first.
■
For single-line touch-tone or rotary telephones, or for any telephone used mainly to call other
extensions, program the extension to select intercom first.
■
For combination extensions, the Automatic Line Selection for both devices (including a tip/
ring device) follows the automatic line selection for the extension.
■
You do not need to include all available lines or pools for an extension, only the ones you want
the system to search through and connect automatically.
Programming
5
To program Automatic Line Selection for an extension:
1. Press
f00ssc
at extension 10 or 11.
2. Enter the number of the extension to be programmed for Automatic Line Selection.
3. Press
**
.
4. Press the line, pool, or
i
buttons in the desired order. The valid entries for Automatic
Line Selection depend upon the type of extension:
■
Key Extension: Outside system lines, Left Intercom (the factory setting)
■
Pooled Extension: Pool 880 button 1, button 2, Left Intercom, Right Intercom (the factory
setting), Pools 881-883, individual lines
For each button pressed, a display similar to the following appears:
Automatic Line Selection
5. To exit Automatic Line Selection, press
**
.
6. Press
c
and enter a new extension number, or exit programming mode.