Avaya ERS 8600 series, Руководство по настройке

Страница: 162 / 420

Procedure steps
Configure an OSPF area by using the following command:
config ipv6 ospf area
<ipaddr>
Variable definitions
Use the data in the following table to use the
config ipv6 ospf area
command.
Variable Value
create [ <type> ][stub-metric
<value> ][translator-role <value> ]
Creates an OSPF area.
• type is the type of area (stub or nssa).
• stub-metric <value> is the cost from 0–16777215.
This is the metric value applied at the indicated type
of service.
• translator-role <value> is either 1 for always or 2 for
candidate.
delete Deletes an OSPF area.
import-summaries <true|false> Configures the area support for importing summary
advertisements into a stub area. Use this entry only if
the stub area is configured to true.
info Displays OSPF area characteristics.
ipaddr Specifies the address of an OSPF area. Use dotted
decimal notation to specify the area name.
nssa <true|false> Configures a not so stubby area (true or false). An
NSSA prevents flooding of normal route
advertisements into the area by replacing them with a
default route.
stub <true|false> Configures the import external option for this area to
be stub or not {true|false}. A stub area uses only one
exit point (router interface) out of the area.
stub-metric <cost> Stub default metric for this stub area.
cost is the range from 0–16777215. This is the metric
value applied at the indicated type of service.
IPv6 routing configuration using the CLI
162 Configuration — IPv6 Routing November 2010