Avaya ERS 8600 series, Руководство по настройке

Страница: 133 / 420

Chapter 8: IPv6 routing configuration using
Enterprise Device Manager
This chapter describes Enterprise Device Manager procedures to configure IPv6 static routes and the
Open Shortest Path First version 3 (OSPFv3) protocol in the Avaya Ethernet Routing Switch 8800/8600.
Routers exchange network topology information with the Open Shortest Path First (OSPF) protocol. For
conceptual information relating to static routes and OSPF, see IPv6 routing fundamentals on page 17.
IPv6 routing configuration navigation
• Creating IPv6 static routes on page 133
• Creating a static default route on page 135
• Enabling OSPF on a router on page 136
• Creating OSPF port interfaces on page 139
• Creating OSPF VLAN interfaces on page 142
• Adding NBMA neighbors on page 145
• Creating OSPF areas on page 147
• Creating a virtual link on page 148
• Specifying ASBRs on page 150
• Inserting OSPF area aggregate ranges on page 152
• Configuring route redistribution on page 153
Creating IPv6 static routes
To improve the static route management, you can change static routes directly with the IPv6
static routing table manager. The static routing table is separate from the system routing table,
which the router uses to control forwarding. Although the tables are separate, entries in the
static routing table manager automatically change in the system routing table if the next-hop
address in the static route is reachable and the static route is enabled.
Use static routes to manually configure routes to destination IPv6 address prefixes.
Configuration — IPv6 Routing November 2010 133