AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 281 / 650

Version 6.6 281 MP-11x & MP-124
User's Manual 25. Configuring Supplementary Services
25.1 Call Hold and Retrieve
Initiating Call Hold and Retrieve:

Active calls can be put on-hold by pressing the phone's hook-flash button.

The party that initiates the hold is called the holding party; the other party is called the
held party.

After a successful Hold, the holding party hears a dial tone (HELD_TONE defined in
the device's Call Progress Tones file).

Call retrieve can be performed only by the holding party while the call is held and
active.

The holding party performs the retrieve by pressing the telephone's hook-flash button.

After a successful retrieve, the voice is connected again.

Hold is performed by sending a Re-INVITE message with IP address 0.0.0.0 or
a=sendonly in the SDP according to the parameter HoldFormat.
Receiving Hold/Retrieve:

When an active call receives a re-INVITE message with either the IP address 0.0.0.0
or the ‘inactive’ string in SDP, the device stops sending RTP and plays a local held
tone.

When an active call receives a re-INVITE message with the ‘sendonly’ string in SDP,
the device stops sending RTP and listens to the remote party. In this mode, it is
expected that on-hold music (or any other hold tone) is played (over IP) by the remote
party.
You can also configure the device to keep a call on-hold for a user-defined time after which
the call is disconnected, using the HeldTimeout parameter.