AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 304 / 650

User's Manual 304 Document #: LTRT-65432
MP-11x & MP-124
2. Configure the parameters as required.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 366 .
26.5 Configuring Authentication
The Authentication page defines a user name and password for authenticating each device
port. Authentication is typically used for FXS interfaces, but can also be used for FXO
interfaces.
Notes:
•
For configuring whether authentication is done per port or for the entire device,
use the parameter AuthenticationMode.
•
If authentication is configured for the entire device, the configuration in this table is
ignored.
•
If the user name or password is not configured in this table, the port's phone
number (configured in the Endpoint Phone Number tableand global password
(configured by the global parameter, Password) are used instead for
authentication of the port.
•
After you click Submit , the password is displayed as an asterisk (*).
•
The Authentication table can also be configured using the table ini file parameter,
Authentication (see 'Configuration Parameters Reference' on page
475 ).

To configure authentication credentials per port:
1. Set the parameter 'Registration Mode' (AuthenticationMode) to Per Endpoint. This
can be configured in any of the following pages:
•
Proxy & Registration page (see 'Configuring Proxy and Registration Parameters'
on page
216 ).
•
Trunk Group Settings page (see 'Configuring Hunt Group Settings' on page 237 ),
where registration method is configured per Trunk Group.
2. Open the Authentication page ( Configuration tab > VoIP menu > GW and IP to IP >
Analog Gateway > Authentication ).
3. Configure port authentication credentials as required. For a description of the
parameters, see the table below.
4. Click Submit to apply your changes.