AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 306 / 650

User's Manual 306 Document #: LTRT-65432
MP-11x & MP-124
Table 26-3: Automatic Dialing Table Parameter Description
Parameter Description
Gateway Port
Lists the FXS or FXO port for which you want to configure automatic
dialing.
Destination Phone Number
[TargetOfChannel_Destina
tion]
Defines the destination telephone number to automatically dial.
Auto Dial Status
[TargetOfChannel_Type]
Enables automatic dialing.

[0] Disable = Automatic dialing for the specific port is disabled.

[1] Enable = (Default) Automatic dialing is enabled and the phone
number configured in the 'Destination Phone Number' field is
automatically dialed if the following occurs:

FXS interfaces: The phone is off-hooked

FXO interfaces: A ring signal (from a PBX/PSTN switch) is
detected on the FXO line. The device initiates a call to the
destination without seizing the FXO line. The line is seized only
after the SIP call is answered.

[2] Hotline = Automatic dialing is done after an interval configured
by the 'Hotline Dial Tone Duration' parameter:

FXS interfaces: When the phone is off-hooked and no digit is
dialed within a user-defined time, the configured destination
number is automatically dialed.

FXO interfaces: If a ring signal is detected, the device seizes
the FXO line, plays a dial tone, and then waits for DTMF digits.
If no digits are detected within a user-defined time, the
configured destination number is automatically dialed by
sending a SIP INVITE message with this number.
Hotline Dial Tone Duration
[TargetOfChannel_HotLine
ToneDuration]
Defines the duration (in seconds) after which the destination phone
number is automatically dialed. This is applicable only if the port has
been configured for Hotline (i.e., 'Auto Dial Status' is set to
Hotline ).
The valid value is 0 to 60. The default is 16.
Note: You can configure this Hotline interval for all ports, using the
global parameter, HotLineToneDuration.