AudioCodes Media Pack MP-11x, Руководство пользователя

Страница: 483 / 650

Version 6.6 483 MP-11x & MP-124
User's Manual 44. Configuration Parameters Reference
Parameter Description
EMS: DNS Information
[SRV2IP]
names into DNS A-Records. Three different A-Records can be assigned
to a host name. Each A-Record contains the host name, priority, weight,
and port. The format of this parameter is as follows:
[SRV2IP]
FORMAT SRV2IP_Index = SRV2IP_InternalDomain,
SRV2IP_TransportType, SRV2IP_Dns1, SRV2IP_Priority1,
SRV2IP_Weight1, SRV2IP_Port1, SRV2IP_Dns2, SRV2IP_Priority2,
SRV2IP_Weight2, SRV2IP_Port2, SRV2IP_Dns3, SRV2IP_Priority3,
SRV2IP_Weight3, SRV2IP_Port3;
[\SRV2IP]
For example:
SRV2IP 0 =
SrvDomain,0,Dnsname1,1,1,500,Dnsname2,2,2,501,$$,0,0,0;
Note : For a detailed description of this table parameter, see 'Configuring
the Internal SRV Table' on page 143 .
44.1.8 DHCP and LLDP Parameters
The Dynamic Host Control Protocol (DHCP) and LLDP parameters are described in the
table below.
Table 44-8: DHCP Parameters
Parameter Description
LLDP Parameters
[EnableLLDP] Enables the device to use the discovery protocol, Link Layer
Discovery Protocol (LLDP) to obtain (over the Layer-2 data link layer)
a VLAN ID for its OAMP interface (per IEEE 802.1, IEEE 802.3 and
TR-41) upon device startup (reset or power up).

[0] = (Default) Disabled

[1] = Enabled
For more information on LLDP, see Section VLAN ID Discovery
using LLDP on page 391.
DHCP Parameters
Web: Enable DHCP
EMS: DHCP Enable
[DHCPEnable]
Enables Dynamic Host Control Protocol (DHCP) functionality.

[0] Disable (default)

[1] Enable
After the device powers up, it attempts to communicate with a BootP
server. If a BootP server does not respond and DHCP is enabled,
then the device attempts to obtain its IP address and other
networking parameters from the DHCP server.
Notes:

For this parameter to take effect, a device reset is required.

After you enable the DHCP server, do the following:
a. Enable DHCP and save the configuration.
b. Perform a cold reset using the device's hardware reset button
(soft reset using the Web interface doesn't trigger the
BootP/DHCP procedure and this parameter reverts to
'Disable').